Motor Ventilation Fans Series CS with insertable bush

Description
Motor Cooling Fans CS are only supplied with a large fixed bore. According to a proprietary principle, a bushing is pressed into the motor shaft, which is available in various bores. If the standard bore does not match, the bushing can easily be clamped in the lathe and turned out accordingly. A vane type usually includes 3-6 bushes, 2-5 of which have a standard bore with two keyways. Another type, type 0, has a cylindrical bore and can be machined to fit thin shafts. The keyway must then be chiseled out. To prevent expansion damage, the bushing and sash are made of the same material.

Three lips are offset at the top and bottom inside the sash. This makes it possible to press in from both sides, whereby the bushing has an even tighter fit in the sash. If necessary, the bushing can now also be pinned to the motor shaft and the sash can then be pressed on. This option is a great advantage, especially with short shaft ends.

In order to ensure the most universal use possible, the curvature of these blades has been kept very flat.
This allows a wider range of different engine makes to be covered. Thanks to a special compound, the material is kept so soft that it is possible to trim the individual blades. One bushing always fits two fan blade sizes.

Dimensions

♦ from stock

Inner Diameters of the available Bushes

♦ from stock

Item number:
Example: BU071/080-14
BU071= master number
080- 14 = hole